MGP WRM2 Manuel d'utilisateur télécharger pdf (Page 36)

15-00043

Revision 3

September 2005

The publication, translation or reproduction, either party or wholly, of this document are not allowed without our written consent. 36

APPENDIX 2

Alternate Network Adapter Configuration:

Network Enabler Software Operation

1. Install the Moxa Network Enabler Administrator

2. Power up the WRM2 base station

3. Connect the network cable to the RJ 45 connector on the WRM2 and to a network hub

4. Launch the Network Enabler Administrator software

5. Click on ‘Configuration’, then ‘Broadcast Search’ to find the factory default IP address

6. The network adaptor with MAC address appears, as depicted in Figure A2-1 below:

Figure A2-1: Network Enabler Software Configuration

7. Double Click’ on the device for programming and the following window is displayed (Figure

A2-2 below):

Figure A2-2: Network Enabler Software Programming

1 2 ... 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

MGP WRM2 Manuel d'utilisateur Page 36